Metal sheet facade | Insertion system short profile
Direct fixing to trapezoidal metal facades
-
material-saving fastening to the high bead
-
short profiles available in different heights
-
module vertical and horizontal mounting possible
-
quick planning in Solar-Planit incl. static verification
Your benefits
creates modern, visually attractive facades
only a handful of components, entirely preassembled
high holding forces thanks to chipless direct fixing with building authority-approved thin sheet screws
a construction with excellent rear ventilation which hangs in front of the building but does not touch it
Components
Components
Click on the + Icons to see components of this mounting system.
Mounting screw E11
- high holding forces thanks to chipless direct fixing
- building authority-approved thin sheet screws
Features
thin sheet metal screw V2A with EPDM seal
5.5x25mm
11mm
03-000893
Mounting screw E16
- high holding forces thanks to chipless direct fixing
- building authority-approved thin sheet screws
Features
thin sheet metal screw V2A with EPDM seal
6.0x25mm
16mm
03-000880
Insertion rails
- high-end installation aesthetics
- time-efficient mounting
- tension-free and floating module mounting
Features
insertion system
portrait & landscape, as cross rail connection or as special assembly
C-rail/C-N-rail/N-rail/short profiles landscape
30-50mm
5.40m-all/2.20m (35mm + 40mm)
yes
03-001417/03-001380/03-001379/03-001416/03-001388/03-001374/03-001378/03-001375
Rail connector set IR
- rail connector works as expansion joint construction at the same time
Features
insertion system
Hexagon key 3mm
insertion rail
65x150mm
yes
03-000648/03-000499
Cross-rail connector IR on C or C-N
- safe connection due to force and form closure
- completely pre-assembled
Features
insertion system
AF 13 hexagon drive
C-rail/C-N-rail/short profile landscape
50x66mm
Edge stop IR
- optically tidy rail ends
- color-coordinated with the insertion rail
- prevents modules from slipping out
Features
insertion system
Torx 30
insertion rail
49x49mm
yes
03-000691/03-000693
Short rail C71 with EPDM 200 mm
- entirely pre-assembled with EPDM-sealing and perforations
- even load distribution thanks to 5 round holes per short profile
- excellent module rear ventilation with extra space to the roof covering
Features
can be used as module support rail
portrait
high
module clamps
71x52 mm
200 mm
-
03-001702
Short rail C47 with EPDM 200mm
- entirely pre-assembled with EPDM-sealing and perforations
- excellent module rear ventilation with extra space to the roof covering
Features
can be used as module support rail or cross rail
landscape
high
module clamps, insertion rails
47x52mm
200mm
-
03-001108
Accessories
Downloads
Module recommendation facade systems
Manufacturer: Aleo Solar, Bauer Solar (AbZ/DIBt), Canadian Solar, EXE Solar, Meyer Burger, SoliTek (AbZ/DIBt), SoLuxTec, Solyco, SunPower Maxeon, SOLARWATT
The values for wind and snow loads (Pa) can be found in the module manufacturer's installation instructions. The load values must be checked individually for each module type. The modules are attached to the short side of the frame using four module clamps. This is a point mounting without continuous substructure rails.
Note: In Germany, modules used in overhead and façade installations require a general building authority approval (AbZ/DIBt).
a = 56 mm
b = 30 - 50 mm
(Frame height)
